SO COOL: Leon Julien’s DIY Kustom FC Holden Wagon

12 Jun

Leon Julien's 1959 FC Holden Wagon

SO COOL

There are FC Holdens and then there is Leon Julien’s FC wagon. Built under a 3x6m marquee, this blown six retro rocket is a total winner
Words & Pics by: www.hoskingindustries.com.au

Leon Julien's 1959 FC Holden WagonWe’ve featured the gamut of custom cars in our time: from high dollar workshop builds with no interesting back story attached, right through to some of the most bare-bones, DIY, budget builds with stories of heroic feats of self-taught snapper twirling the world has ever known and everything in between. Then there’s 37-year-old Leon Julien and his FC wagon known as FCCOOL.

“I’ve had an interest in FC Holdens since I was about six years old,” Leon says. “My uncle had a van that he ended up rebuilding. But it wasn’t until year seven in high school that I travelled over night from Sydney to Grafton in that van that I made it a life goal to build my own FC and do the same trip.”

By rights, we should not be drooling over Leon’s retro-chic FC, but instead looking on lovingly at an FE sedan. “I only bought the FC wagon as a parts car for the FE I was building,” Leon says. “But when I got it, I realised it still had nine months rego on it, so I drove it for those nine months and became attached to it.”

This was way back in 1995, when grunge was still going about its business of killing hair metal and the country was emerging from the ‘recession we had to have’. With the decision made to swap trajectories and rebuild the wagon, the dash and the engine block from the FE sedan were swapped over to the FC, but it can’t have been much to look at at the time.Leon Julien's 1959 FC Holden Wagon

“It had house paint covering any repairs when I got it,” Leon says. “There were undressed welds, dents whacked out with a hammer and mould on the roof and bonnet, but it had a good running grey motor and three-on-the-tree.”

This is where the story starts becoming truly remarkable. Without the aid of even the most rudimentary single-car garage to work in, Leon resorted to performing the bulk of the work on the car under the meagre shelter of a 6x3m marquee!

Over time, Leon restored the existing metal work and significantly altered it along the way. Look closely, past the more obvious custom grille (featuring door knobs as depicted in a ‘how-to’ article from 1963) and slanted 1953 Edsel head light mods, to the shaved handles and side chrome, frenched tail lights and aerial holes, front indicators, EK tail gate, radiused door openings and bonnet treatment. Leon’s FC is a smorgasbord of tasty metal mods that’ll have you gawking for hours – all performed in the front yard!

“One of my favourite moments during the build would have been the morning after I put the final coats of paint on,” Leon says. “I was pulling all-nighters in the driveway, watching the sun rise as I put parts back on the car while neighbours peered through their blinds, thinking I was nuts.”

Leon Julien's 1959 FC Holden WagonLeon’s retro-rific rig isn’t all about the bodywork, though – as impressive it is that he could pull off such a good job in the front yard. The FC also boasts a tough little Holden six.

Built around the 179ci that Leon originally had in his FE, Westend Performance built him up a nice 208ci stroker using 3.3L rotating parts, held together with ARP studs and fasteners. The cast head was ported and treated to a meaty solid valvetrain, helping the breathing even further. If that weren’t enough, Leon went about fabricating a trick blower setup using a Commodore-spec’ Eaton M90 supercharger that he’s got rigged up to run 8psi.

This combo is backed by a Trimatic and an old Banjo rear end that’s holding up to the punishment so far. “I’ve been running this engine block since 1994 and have given it a good workout in that time,” he says. “I don’t really understand why people always say these things are weak.”

“I built this car for the odd trip down the drag strip, carting the family on long distance trips to car shows and cruising around town,” he says. “It goes like the clappers, drives quite smoothly, doesn’t use a lot of fuel and has pretty good throttle response. I love that it also seems to get more attention than a lot of other high-dollar builds.”

With a slew of trophies under its belt already and with the Julien clan attending plenty of shows up and down the east coast, the FC is sure to continue winning fans the more it’s seen. However, it’s unlikely to look the same each time you see it, with Leon continually working to improve the package.

All hail the DIY king!

VEHICLE: 1959 FC Holden
OWNER: Leon Julien
BODY: White/blue two tone (high opacity white, tinted with green/blue tinter under white pearl), custom grille, frenched tail lights, all seams welded, EK tail gate, door corners radiused, guards welded to body, shaved handles, side trim shaved, twin frenched aerial holes, hood corners radiused, frenched indicators, canted 1958 Edsel headlights
ENGINE: 1964 179ci Holden six (stroked to 208ci), block decked and O-ringed, Holden black 3.3L crank, 3.3L rods, ACL Race Series pistons, ARP mains stud kit, ACL bearings, ported cast head, copper head gasket, Camtech solid cam’, Yella Terra 1.5:1 rockers, Manley pushrods, straight-cut gear drive, JP high-volume oil pump, EH sump, 2x 14in thermo fans, HQ V8 radiator, 85A alternator, Ross balancer, custom blower pulley, modified HS8 SU carb’, Eaton M90 supercharger (8psi), regraphed Bosch VK Commodore electronic distributor, Crane Cams LX92 coil, Crane Hi6 TRC-2 w/map sensor, custom wiring harness, Mallory Comp 140 fuel pump, Mallory billet FPR, 6-2-1 headers, 2.75in mild steel exhaust, H&M muffler
TRANS: Trimatic, 2800rpm stall, modified valve body
DIFF: Banjo, 2.78:1 final drive, LX Torana tail shaft
INTERIOR: Repainted EH Holden steering wheel, custom plush pile carpets, white vinyl roof lining, chromed instrument cluster fascia and glove box, NOS 1960’s Stewart Warner gauges, JVC head unit, Rockford Fosgate power amp’, Cerwin Vega front speakers, Diamond Audio rear speakers, Sony 6x9in behind factory dash grille, Dynamat Extreme sound deadener
SUSPENSION: HR Holden front, Pedders front springs, Gabriel shocks, reset rear leaf springs, adjustable Gabriel rear shocks, on-board compressor and control solenoids for rear, HR Holden steering arms, EH Holden steering column, 50x50mm box from sub frame to leaf spring hangers
BRAKES: HR Holden front discs, HR rear drums, Bendix pads and shoes, VH40 booster, braided lines
WHEELS: Stock 13in steel rims
THANKS TO: West End Performance, Active Transmissions, Motorsport Connections, Better Brakes – Blacktown, American Autos, FC/FC Holden forum, GMH Torana forum, OzRodders forum

Tags: , , , , , , , , , , , , , , , , , , , , , , , ,

Leave a Reply